You aren't just looking for a free beer are you?
Jerry
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On
Behalf Of Brad Velander
Sent: Tuesday, April 04, 2006 10:07 AM
To: Protel EDA Discussion List
Subject: Re: [PEDA] how to convert PCB to graphic
Kathy,
The other method that could work as well is to import the former
top/bottom layer Gerbers to a mechanical layer. P99SE is particular about
importing Gerbers but in this case since the originals were Protel
generated, it should be accomplished without many difficulties.
We do this quite often for all layers of PCBs to determine where and
how precisely changes were incorporated to a board design revision.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Kathy Quinlan [mailto:[EMAIL PROTECTED]
Sent: Tuesday, April 04, 2006 6:42 AM
To: Protel EDA Discussion List
Subject: Re: [PEDA] how to convert PCB to graphic
Thanks Leo,
It worked great :)
The next time you come to Perth Au, let me know I will buy you a beer
mate :)
--
Regards,
Kat.
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
