windex is sort of interesting, never heard of using that are you sure it leaves no residues ?
what is in the blue color? and what about compatibility of ammonia with parts ? Dennis Saputelli _______________________________________________________________________ CONTACT INFORMATION: _______________________________________________________________________ Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 2851 21st Street Fax: 415-647-3003 San Francisco, CA 94110 www.integratedcontrolsinc.com _______________________________________________________________________ NOTE! TO PASS OUR SPAM FILTER PUT THE FOLLOWING IN SUBJECT LINE: I.C.I. Brooks,Bill wrote: > Hmm... sure is a lot more complicated that the old days where we grabbed a > bottle of Trichloroethylene and an acid brush and went to the sink and > washed it all off... In fact we made a degreaser using Trichlor and it > worked great! Took off the toughest flux residues... > Too bad it's outlawed now... Or MEK (Methyl Ethyl Ketone) worked pretty good > too. Ahhh.. the good ol' days... > > :) > > > Bill > -----Original Message----- > From: Brian Guralnick [mailto:[EMAIL PROTECTED] > Sent: Friday, December 15, 2006 5:46 AM > To: Protel EDA Discussion List > Subject: Re: [PEDA] "No-clean" flux leakage, was: (500V power supply) > > Ok, my method of re-cleaning no-clean flux.... > > Use an electronic sonic tooth-brush going through a flux-cleaning solvent > cycle, then, windex cycle, then, hot water cycle, then back to windex. > Windex was chosen since it completely evapourates & take any water with it. > > This was the only way I could completely remove any electrical effect left > by the no-clean flux. > > Note that I was measuring effect in the micro-amp & nano-amp regions where > battery powered circuits, eg-32Khz oscilators, super-low powered radio > recievers, have a measurable effect. > > ______________________ > Brian Guralnick > Vergent Technologies Inc. > 438 Brahms Ave. > Dollard Des Ormeaux > Quebec, Canada > H9G 2S6 > (514) 624-4003 > [EMAIL PROTECTED] > > > > > ____________________________________________________________ > You are subscribed to the PEDA discussion forum > > To Post messages: > mailto:[email protected] > > Unsubscribe and Other Options: > http://techservinc.com/mailman/listinfo/peda_techservinc.com > > Browse or Search Old Archives (2001-2004): > http://www.mail-archive.com/[email protected] > > Browse or Search Current Archives (2004-Current): > http://www.mail-archive.com/[email protected] > > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
