Dennis,
Yeah! You get a yard of beer if ever we should meet. I didn't do the
actual install and this designer doesn't normally do installs, so he forgot or
didn't realize there should be the service pack 6 installed. I guess he did the
same thing last time but didn't realize it until he was asking me today about
what could cause this problem.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2232 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Dennis Saputelli [mailto:[EMAIL PROTECTED]
Sent: Friday, January 19, 2007 3:34 PM
To: Protel EDA Discussion List
Subject: Re: [PEDA] P99SE: Design Rule setup/config problem after clean
install on a new laptop.
the only idea i have is that it is not SP6 ?
the keepout check box is real crowded in there like an afterthought
so it sort of sounds like a version issue
other than that as a really wild guess i wonder if some 'server' is not
installed that makes that feature available but i sort of doubt it
Dennis Saputelli
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
