On Fri, Sep 11, 2020 at 2:26 PM Chuck Hast <wch...@gmail.com> wrote: > I got it going, I had to disable STP on the B switch side. I have a > SG300 (switch A) here at home, and I also have a SG200 (switch > B). I have the 300 setup with port 28 (it is a 28 port switch) as the trunk > for > VLAN 20. Did same thing for port 52 on the SG200 (SW B) and the > usual no joy, it appeared that I had met all of the requirements that > you had listed but the stinking Spanning Tree on Switch B was > discarding, I went in and disabled it and now it all talks. That will get > me going until I figure out how to re-enable STP on that port and make > it forward. >
You can try either setting the trunk ports on both sides to enable edge port to use fast-link so the ports automatically forward when physical link is established. https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-small-business-200-series-smart-switches/smb81-setup-spanning-tree-protocol-stp-on-a-interface-on-the-200-3.html Also, check and try different global spanning tree configurations. https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-small-business-200-series-smart-switches/smb3209-configure-spanning-tree-protocol-stp-status-and-global-setti.html I wish I could give you better advice regarding Spanning Tree but I despise it and I think it's the bane of networking. I never trusted it and it often found it caused more problems. _______________________________________________ PLUG: https://pdxlinux.org PLUG mailing list PLUG@pdxlinux.org http://lists.pdxlinux.org/mailman/listinfo/plug