Thank you. I am going to install latest version of CMake and see if I can track a more descriptive error down. Checked log files and no particular error message issued. Using GUI of CMake. Using my 'workaround' PoDoFo compiled correctly and linked with my application. Tested some PDF's without any issues.
Regards -----Original Message----- From: zyx [mailto:z...@litepdf.cz] Sent: 08 August 2016 08:13 To: Anton Heymann <anton.heym...@cad-essence.com> Subject: Re: [Podofo-users] CMake 2.8 and Podofo 0.9.4 and VS2008 On Sun, 2016-08-07 at 15:03 +0100, Anton Heymann wrote: > Did not want to go into any more detail. Just wanted to see if anybody > is 'out there' looking at these kind of posts. It was simply a generic > error from CMake 2.8 which states that it cannot continue, as there > are errors, so it is a vague as I was. Anyway. Resolved it by using a > cmakelists.txt from 0.9.3 and copying to 0.9.4 folder. > Edited versions etc and solution and project files were generated > correctly. Used VS2008 then to build PoDoFo fine and dandy. My > question is however, should 0.94. makefiles.txt not produce project > files, if all (ZLIB, PNG, FREETYPE etc.) dirs and libs are specified? Hi, you replied only to me, not to the list, accidentally? Please reply to the list instead. By the way, the CMake generates a log and an error log, which you can read to see what went wrong. it's usually shown also above the "vague error", if you use the command line cmake, not the GUI. Replacing the file from 0.9.3 is wrong, from my point of view. Again, it depends on the exact error message CMake produced. (I may repeat this paragraph to your list reply once you'll do that.) Bye, zyx ------------------------------------------------------------------------------ _______________________________________________ Podofo-users mailing list Podofo-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/podofo-users
