Per Jessen wrote: > I always run the mprime stress test on newly assembled systems - sort of as a > burn-in. On a > system I've just built - AOpen board, Intel Celeron 2GHz, 256MB RAM, all new > components - I'm > see hardware errors during the stress-test (see below) - doesn't seem to be > consistent though. > > I happen to have two of all the components, so I could start swapping them > around - but, any > suggestions as to what is likely to be the culprit here? The board isn't > overclocked or > anything like that, the memory is even running slightly slower than it should > (faulty SPD I > suspect).
OK, I've just now changed to board #2, but kept the memory. So, new CPU+board. Same problem - still hardware errors reported by stress test. I'm now running a memory-check which should be really interesting. The memory is also new, but of 2 sticks bought, only one actually worked - the other is being RMAed. -- /Per Jessen, Z�rich _______________________________________________ Prime mailing list [email protected] http://hogranch.com/mailman/listinfo/prime
