I have pushed a change that might be a fix. Update your Dissect addon.
The mouse-move routine returned a value that was being displayed. I
changed it to return i. 0 0. That made the 0s go away for me. I think
the display is probably only when debug is on, and was introduced toward
the end of 9.02 development. Normally the results of event handlers are
not displayed, but for debug they are passed into the suspension handler
which then displays them.
Henry Rich
On 1/23/2021 12:09 AM, 'robert therriault' via Programming wrote:
I was going through the J by point and click lab and noticed that there is a
problem with the dissect window in j902 and j903. Whenever I move the mouse
over the dissect window a sequence of 0's races down the page of my term
window. I don't see this behaviour j901 or earlier.
Is this happening for anyone else?
I had been hoping to run a series of videos based on this lab to provide an
easy entry to J from the masses, but would not want to do that if it not
reliable across versions.
Was this lab yours Henry? It is a very good introduction.
Cheers, bob
JVERSION(s)
JVERSION
Engine: j903/j64avx2/darwin
Beta-a: commercial/2020-12-17T10:25:30
Library: 9.03.01
Qt IDE: 1.9.2/5.12.10(5.12.10)
Platform: Darwin 64
Installer: J903 install
InstallPath: /users/bobtherriault/j903
Contact: www.jsoftware.com
JVERSION
Engine: j902/j64avx2/darwin
Release-a: commercial/2020-12-05T12:43:38
Library: 9.02.08
Qt IDE: 1.9.1/5.12.10(5.12.10)
Platform: Darwin 64
Installer: J902 install
InstallPath: /users/bobtherriault/j902
Contact: www.jsoftware.com
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
--
This email has been checked for viruses by AVG.
https://www.avg.com
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
