Hi Mike,
Look at page 7 of 14 in the document pointed to by the following address.
It will show you the pin out.
http://catalog.tycoelectronics.com/TE/docs/pdf/7/95/158597.pdf
Best regards,
Max P. Henzi, CEO
Lavenir Technology
2440 Estand Way
Pleasant Hill, CA 94523
voice: (925) 680-7400 fax: (925) 686-5131
email: [EMAIL PROTECTED]
Web: www.lavenir.com
-----Original Message-----
From: Mike Reagan [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, August 07, 2001 3:58 PM
To: Protel EDA Forum
Subject: Re: [PEDA] Amp Connector
> You have two rows of contacts in the connector, but four rows of pads on
> the board (plus the center ground row)
>
Which brings up the question where is pin 3 and pin 4 located. Sorry we are
tying up this forum with my dumb question.
Mike
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *