Hi Krister, By what you're describing, it sounds to me like you're opening a session that was previously (at some point) either created or modified on a Pro Tools system with a different I/O setup. Thus, the input and output paths were different. One way to fix the problem would be to go to the I/O setup dialog and perform the following actions for both the input and output tabs. Command-1 on the numbers row for input, Command-2 for output, etc. You might want to do the same for busses unless there's complex routing that you don't wish to have to recreate. Also, if there's automation, you'll lose it by performing these actions.
With one of the tabs selected, press Command-a to select all of the paths. Find the Delete Path button and press it. Confirm the delete. Find the Default button and press it. Again, repeat the above steps for relevant tabs in the dialog and press OK. This should eliminate the session notes coming up unless it has to do with unavailable plug-ins, in which case, you either live with it if you don't wish to eliminate the plug-ins from the session or just remove the plug-ins from the tracks where the plug-ins are unavailable. Hope that makes sense. Slau On Mar 21, 2014, at 8:08 AM, Krister Ekstrom <kris...@kristersplace.com> wrote: > Hi, > Here comes a couple of stupid newbie questions to brighten up your friday: > So, i'm in this session notes dialog that pops up everytime i open Pro tools > 11. There's a text grid view list that says something to the effect that some > plugins have been disabled because they couldn't be found in the path, and > that's quite ok because i haven't installed them as of yet, but then comes > another message saying that some bus paths were unassigned because they > couldn't be found or something to that effect and then it says to go to the > i/o settings to get more information, but me dumb as i am don't even know > what to look for let alone what to change to get the program satisfied. How > do i know what to change? > /Krister > > -- > You received this message because you are subscribed to the Google Groups > "Pro Tools Accessibility" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to ptaccess+unsubscr...@googlegroups.com. > For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Pro Tools Accessibility" group. To unsubscribe from this group and stop receiving emails from it, send an email to ptaccess+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.