Am 24.11.21 um 15:45 schrieb Ralf Storm: > Hello Stefan, > > I had the old Firmware (from2015?) 000..26 - the ri version not the it > version - this did not work > on the 5.13 Kernel - stuck at boot and server rebooting after a while > > the newest version i found was from 2016 000..27 , which works, it is hard to > find any firmwares as > the vendor does not supply it anymore, there are descriptions howto update > and links to the > firmware, but the links are dead... >
If you go to https://www.broadcom.com/support/download-search and then: Product Group -> Legacy Products (all the way down) Product Family -> Legacy Host Bus Adapters Product Name -> SAS 9211-8i Host Bus Adapter => Search you will find all firmware versions and related tools, docs, etc. that Broadcom shares. The latest available firmware is 20.00.07.00 dated 2016-04-04. > Has to be updated in efi shell from usb drive > > > hope that helps, > > best regards > > Ralf > > > Hi Ralf > > Would you mind to share the old and new firmware versions of your controller > and your kernel version? > > It might help other PVE users to avoid the problem you have run into. > > Thank you > > Stefan > >> On Nov 24, 2021, at 11:24, Ralf Storm<[email protected]> wrote: >> >> Hello, >> >> >> Proxmox is starting again after upgrading the firmware of the 9211-8i >> controllers... >> >> And yes it did boot with the old Kernel, so the Firmware of the controllers >> was incompatible with >> thie new Kernel. >> >> >> Ralf Storm >> >> >> Systemadministrator >> >> >> >> Konzept Informationssysteme GmbH >> >> Am 23.11.2021 um 14:37 schrieb Uwe Sauter: >>> Am 23.11.21 um 14:34 schrieb Ralf Storm: >>>> Hello, >>>> >>>> >>>> yes - I have a problem, as mentioned in my first mail, the system is stuck >>>> at boot with this >>>> message >>>> and then after a few minutes reboots... >>> Can you reboot with the previous kernel and check the firmware of the >>> controller? >>> >>> dmesg | grep mpt | grep -i fw >>> >>> should show the firmware version. >>> >>> >>>> Am 23/11/2021 um 14:14 schrieb Uwe Sauter: >>>>> Am 23.11.21 um 14:04 schrieb Ralf Storm: >>>>>> Hello, >>>>>> >>>>>> I´m currently upgrading my 7-node Cluster, 1 node without problems, 2 >>>>>> nodes had renamed NICs >>>>>> to be >>>>>> corrected, >>>>>> >>>>>> but the last Node stucks at boot with this message: "mpt2sas_cm0: >>>>>> overiding NVDATA EEDPTagMode >>>>>> setting" >>>>>> >>>>>> Anybody had this error before? >>>>> Yes, unrelated to Proxmox. But the SAS controller works fine even with >>>>> this message. >>>>> >>>>> Do you have issues accessing your storage? >>>>> >>>>>> Best regards >>>>>> >>>>> _______________________________________________ >>>>> pve-user mailing list >>>>> [email protected] >>>>> https://lists.proxmox.com/cgi-bin/mailman/listinfo/pve-user >> _______________________________________________ >> pve-user mailing list >> [email protected] >> https://lists.proxmox.com/cgi-bin/mailman/listinfo/pve-user > _______________________________________________ > pve-user mailing list > [email protected] > https://lists.proxmox.com/cgi-bin/mailman/listinfo/pve-user _______________________________________________ pve-user mailing list [email protected] https://lists.proxmox.com/cgi-bin/mailman/listinfo/pve-user
