Mike Isely wrote: > That dump is a mixture of ivtv and pvrusb2 related messages. While we > can pick that apart, it'd be better just to run that 'cat > /sys/class/pvrusb2/*/debuginfo' command and THEN look at the log.
I was wondering if my setup is bothered by the internal PVR-150, so I took an old laptop (450MHz) that has 2.6.15. I reconfigured the kernel, installed mplayer and your latest driver, etc. It behaves exactly like my desktop. The radio is mono but the sound changes a little when I toggle ctl_audio_mode, but still mono. I could send you a recorded example if you like. Here is the dump in case it's useful. I do this while the radio is playing. Is that right? The log has very little info. Is that because I don't have ivtv installed? Should I? The radio and tv seem to work without it on this laptop. (sorry about the line wrap) rickmvnote:~# cat /sys/class/pvrusb2/*/debuginfo big lock free; ctl lock free driver flags: initialized ok connected Subsystems enabled / configured: +ENC_FIRMWARE +ENC_CFG +DIG_RUN +USB_RUN +ENC_RUN Subsystems disabled / unconfigured: Attached I2C modules: MSP3445G-B8 @ 0x40 (handler: pvrusb2-audio v4l1) [v4l1_standard v4l1_volume v4l1_freq] i2c IR (Hauppauge) @ 0x18 [v4l2_standard v4l2_audiomode v4l2_bcsh v4l2_volume v4l2_freq v4l2_size v4l2_log] Philips NTSC MK3 (FM1236MK3 or FM1236/F) @ 0x61 (handler: pvrusb2-tuner) [v4l2_standard v4l2_audiomode v4l2_bcsh v4l2_volume v4l2_freq v4l2_size v4l2_log] tda9887 @ 0x43 (handler: pvrusb2-demod) [v4l2_standard v4l2_audiomode v4l2_bcsh v4l2_volume v4l2_freq v4l2_size v4l2_log] tveeprom @ 0x50 [v4l2_standard v4l2_audiomode v4l2_bcsh v4l2_volume v4l2_freq v4l2_size v4l2_log] saa7115 @ 0x21 (handler: pvrusb2-video-v4l (old routing)) [v4l2_standard v4l2_audiomode v4l2_bcsh v4l2_volume v4l2_freq v4l2_size v4l2_log] Jan 22 12:48:43 rickmvnote kernel: pvrusb2: ================= START STATUS CARD #0 ================= Jan 22 12:48:43 rickmvnote kernel: tda9887 0-0043: Data bytes: b=0c c=90 e=1d Jan 22 12:48:43 rickmvnote kernel: saa7115 0-0021: Audio frequency: 48 kHz Jan 22 12:48:43 rickmvnote kernel: saa7115 0-0021: Video signal: bad Jan 22 12:48:43 rickmvnote kernel: saa7115 0-0021: Frequency: 60Hz Jan 22 12:48:43 rickmvnote kernel: saa7115 0-0021: Detected format: BW/No color Jan 22 12:48:43 rickmvnote kernel: pvrusb2: ================== END STATUS CARD #0 ================== Here is the log from bootup: Jan 22 11:56:21 rickmvnote kernel: usbcore: registered new driver pvrusb2 Jan 22 11:56:21 rickmvnote kernel: /usr/local/src/pvrusb2/pvrusb2-mci-20070121/driver/pvrusb2-main.c: Hauppauge WinTV-PVR-USB2 MPEG2 Encoder/Tuner : 20070121 (from www.isely.net) Jan 22 11:56:21 rickmvnote kernel: /usr/local/src/pvrusb2/pvrusb2-mci-20070121/driver/pvrusb2-main.c: Debug mask is 15 (0xf) Jan 22 11:56:21 rickmvnote kernel: usb 1-1: reset full speed USB device using uhci_hcd and address 2 Jan 22 11:56:21 rickmvnote kernel: msp3400 0-0040: chip=MSP3445G-B8 +nicam +simple +simpler +radio mode=simpler Jan 22 11:56:21 rickmvnote kernel: msp3400 0-0040: msp34xxg daemon started Jan 22 11:56:21 rickmvnote kernel: input: i2c IR (Hauppauge) as /class/input/input4 Jan 22 11:56:21 rickmvnote kernel: tuner 0-0061: chip found @ 0xc2 (pvrusb2_a) Jan 22 11:56:21 rickmvnote kernel: tda9887 0-0043: chip found @ 0x86 (pvrusb2_a) Jan 22 11:56:21 rickmvnote kernel: saa7115 0-0021: saa7115 found @ 0x42 (pvrusb2_a) Jan 22 11:56:21 rickmvnote kernel: tveeprom 0-0050: Hauppauge model 29032, rev D158, serial# 7570160 Jan 22 11:56:21 rickmvnote kernel: tveeprom 0-0050: tuner model is Philips FM1236 MK3 (idx 58, type 43) Jan 22 11:56:21 rickmvnote kernel: tveeprom 0-0050: TV standards NTSC(M) (eeprom 0x08) Jan 22 11:56:21 rickmvnote kernel: tveeprom 0-0050: audio processor is MSP3445 (idx 12) Jan 22 11:56:21 rickmvnote kernel: tveeprom 0-0050: decoder processor is SAA7115 (idx 19) Jan 22 11:56:21 rickmvnote kernel: tveeprom 0-0050: has radio, has IR remote Jan 22 11:56:21 rickmvnote kernel: tuner 0-0061: type set to 43 (Philips NTSC MK3 (FM1236MK3 or FM1236/F)) Jan 22 11:56:21 rickmvnote kernel: Adding 377992k swap on /dev/hda2. Priority:-1 extents:1 across:377992k Jan 22 11:56:21 rickmvnote kernel: tda9887 0-0043: Data bytes: b=14 c=30 e=44 Jan 22 11:56:21 rickmvnote kernel: saa7115 0-0021: Audio frequency: 48 kHz Jan 22 11:56:21 rickmvnote kernel: saa7115 0-0021: Video signal: bad Jan 22 11:56:21 rickmvnote kernel: saa7115 0-0021: Frequency: 60Hz Jan 22 11:56:21 rickmvnote kernel: saa7115 0-0021: Detected format: BW/No color Jan 22 11:56:21 rickmvnote kernel: pvrusb2: Device initialization completed successfully. Jan 22 11:56:21 rickmvnote kernel: pvrusb2: registered device video0 [mpeg] Jan 22 11:56:21 rickmvnote kernel: pvrusb2: registered device radio0 [mpeg] ...RickM... _______________________________________________ pvrusb2 mailing list [email protected] http://www.isely.net/cgi-bin/mailman/listinfo/pvrusb2
