No, but thanks for the info!! The devices (yes, it's two of them ☺) do seem to run a little hot so that may be a factor here on why they're hanging. I'll also look into getting them a decent power supply. Cheers!
On Sat, 2019-03-16 at 16:48 +0000, Gary Buhrmaster wrote: > On Sat, Mar 16, 2019 at 4:06 PM Diego Rivera <[email protected]> > wrote: > Every so often one of the devices ceases to function and just "dies". > It has been a long long time since I touched one ofthose, but I would always > look at the root > causesof the hangs first..... > The two most common issues with the HVR-1950that I ran into is that it can > overheat (and hang)and > the power supply can be going bad (and thedevice hangs). > For the first, I found avoiding stacking them (whichI had been doing) was > sufficient to avoid > overheating(although your location may vary and you may needactive airflow), > and for the second, I > replaced thepower adapter. FWIW, I don't think any of thepower adapters that > I ever got from > Hauppaugewere of good quality, and I usually just replaced thempro-actively > with a high quality > switching supply(at the time I had a local source of delta brandedoem > switching supplies that were > dirt cheap andnew in box). Note that you typically can't just usea VOM on > the adapter to test, > you have to put theadapter under load and look at the ripple. Usuallyjust > easier to replace the > power supply. > And none of this was actually in response tothe question you > asked..._______________________________________________pvrusb2 mailing > [email protected] > http://www.isely.net/cgi-bin/mailman/listinfo/pvrusb2 -- Diego Rivera
signature.asc
Description: This is a digitally signed message part
_______________________________________________ pvrusb2 mailing list [email protected] http://www.isely.net/cgi-bin/mailman/listinfo/pvrusb2
