I have no idea what it did, but now qemu behaves like it should have done from the beginning :-). Now error messages are finally printed. Thanks a lot!
The was a network problem, "GetNetworkParams failed. ret = 00000032. Could not get DNS address". GetNetworkParams is not supported in NT4, so that's probably why it crash. I used "-nics 0" to solve the problem, and now it starts again. I will test more in the weekend and report what I have found. Thanks again. PEK ----- Original Message ----- From: "Jernej Simončič" <[EMAIL PROTECTED]> To: "Per-Erik Kristensson on [qemu-devel]" <qemu-devel@nongnu.org> Sent: Tuesday, April 26, 2005 11:01 PM Subject: Re: [Qemu-devel] Re: qemu.exe, QEMUMenu.bat and qemu-forum doesn't On Tuesday, April 26, 2005, 21:54:03, Per-Erik Kristensson wrote: > The silent crashes are very annoying. I tested a nightly build but that > behaved the same. If anyone have a solution I'm willing to test that. I attached a small utility that can change a GUI program into a console program (and vice-versa). Use it with qemu, then run qemu from command-line, and you should see why it's failing. -- < Jernej Simoncic ><><><><>< http://deepthought.ena.si/ > Enough research will tend to support your theory. -- Law of Research ---------------------------------------------------------------------------- ---- > _______________________________________________ > Qemu-devel mailing list > Qemu-devel@nongnu.org > http://lists.nongnu.org/mailman/listinfo/qemu-devel > _______________________________________________ Qemu-devel mailing list Qemu-devel@nongnu.org http://lists.nongnu.org/mailman/listinfo/qemu-devel
