On 11/03/2015 04:56 AM, zhanghailiang wrote: > We need communications protocol of user-defined to control the checkpoint > process. > > The new checkpoint request is started by Primary VM, and the interactive > process > like below: > Checkpoint synchronizing points, > > Primary Secondary > 'checkpoint-request' @ -----------------------------> > Suspend (In hybrid > mode) > 'checkpoint-reply' <------------------------------ @ > Suspend&Save state > 'vmstate-send' @ -----------------------------> > Send state Receive state > 'vmstate-received' <------------------------------ @ > Release packets Load state > 'vmstate-load' <------------------------------ @ > Resume Resume (In hybrid mode) > > Start Comparing (In hybrid mode) > NOTE: > 1) '@' who sends the message > 2) Every sync-point is synchronized by two sides with only > one handshake(single direction) for low-latency. > If more strict synchronization is required, a opposite direction > sync-point should be added. > 3) Since sync-points are single direction, the remote side may > go forward a lot when this side just receives the sync-point. > 4) For now, we only support 'periodic' checkpoint, for which > the Secondary VM is not running, later we will support 'hybrid' mode. > > Signed-off-by: zhanghailiang <zhang.zhanghaili...@huawei.com> > Signed-off-by: Li Zhijian <lizhij...@cn.fujitsu.com> > Signed-off-by: Gonglei <arei.gong...@huawei.com> > Cc: Eric Blake <ebl...@redhat.com> > --- > v10: > - Rename enum COLOCmd to COLOCommand (Eric's suggestion). > - Remove unused 'ram-steal'
Interface review only: > +++ b/qapi-schema.json > @@ -702,6 +702,33 @@ > '*tls-port': 'int', '*cert-subject': 'str' } } > > ## > +# @COLOCommand > +# > +# The colo command Still might be nice to spell out what COLO means here, but it's fairly obvious this will be related to anything else COLO, so I'm not too worried. > +# > +# @invalid: unknown command > +# > +# @checkpoint-ready: SVM is ready for checkpointing > +# > +# @checkpoint-request: PVM tells SVM to prepare for new checkpointing > +# > +# @checkpoint-reply: SVM gets PVM's checkpoint request > +# > +# @vmstate-send: VM's state will be sent by PVM. > +# > +# @vmstate-size: The total size of VMstate. > +# > +# @vmstate-received: VM's state has been received by SVM > +# > +# @vmstate-loaded: VM's state has been loaded by SVM > +# > +# Since: 2.5 Will need a tweak to say 2.6. Otherwise looks okay. > +## > +{ 'enum': 'COLOCommand', > + 'data': [ 'invalid', 'checkpoint-ready', 'checkpoint-request', > + 'checkpoint-reply', 'vmstate-send', 'vmstate-size', > + 'vmstate-received', 'vmstate-loaded' ] } > + -- Eric Blake eblake redhat com +1-919-301-3266 Libvirt virtualization library http://libvirt.org
signature.asc
Description: OpenPGP digital signature