I have a test environment and a production environment.
The following works in test and NOT in production. The test
environment is a single system running openLDAP (version 2.0.15)
and qmail-LDAP (20011001a) with multiple domains configured as
follows within openLDAP:
dc=domain1.com,ou=clients,o=load,c=us
dc=domain2.com,ou=clients,o=load,c=us
...
Then for Common Names (objectClass: qmailUser):
cn=name,dc=domain1.com,ou=clients,o=load,c=us
cn=name,dc=domain2.com,ou=clients,o=load,c=us
...
Now, I can send an email to [EMAIL PROTECTED] and [EMAIL PROTECTED]
and they are resolved properly and delivered to their prospective
Mailboxes or forwarded to mailForwardingAddress as defined.
But in the production environment in which the openLDAP and qmail-LDAP
services are running on separate systems, the qmail-LDAP servers
do not resolve the email address properly... I have compared the
control files side by side and I cannot figure out where I am
going wrong... I have tried using qmail-ldaplookup and I have
put the LDAP server into debug mode and strangely any check of
an email address does a strange lookup through all the domains.
This is not the same performance as in test on a single system.
Any advice would be absolutely appreciated!
-- LOAD your email!
Timothy Lorenc USmail: Lorenc Advantage, Inc.
Consultant 6732 E. State Blvd.
PMB 304
Email: [EMAIL PROTECTED] Fort Wayne, IN 46815
http://www.load.com
***DISCLAIMER***
If this communication concerns the negotiation of a contract or agreement,
the Uniform Electronic Transaction Act does not apply to this communication:
contract and/or agreement formation in this matter shall only occur with
manually-affixed signatures on original documents.
