Bill Isaacs <[EMAIL PROTECTED]> wrote:
> After installing this package, I found that I could not login to check my
> email (ERR: authorization failed). I had to uncomment the pop-3 and smtp
> lines in inetd.conf to be able to connect to the server at all (these had
> been commented out during by the installation routine).
relay-ctrl relies on tcpserver. You can't run it out of inetd. Change your
pop3 configuration to use tcpserver as documented.
> I am trying to use this package so that I can relay from my home workstation
> in California with a dynamic IP address.
>
> Any advice?
Send your mail through your ISP's smarthost -- that's what they're for.
relay-ctrl is not needed for most situations, and this appears to be one
of them.
Charles
--
-----------------------------------------------------------------------
Charles Cazabon <[EMAIL PROTECTED]>
GPL'ed software available at: http://www.qcc.sk.ca/~charlesc/software/
Any opinions expressed are just that -- my opinions.
-----------------------------------------------------------------------