After following your instructions in great detail I was able to get off this list.
Thank you so much...
- Lucas
in your On Tue, 29 May 2001 11:32:27 -0400
"Dave Sill" <[EMAIL PROTECTED]> wrote:
-> Lukasz Gogolewski <[EMAIL PROTECTED]> wrote:
->
-> >How do i get off this list?
->
-> Sigh. This has become such a FAQ that I'm reposting the detailed
-> instructions:
->
-> First, ask your Internet Provider to mail you an Unsubscribing Kit. Then
-> follow these directions.
->
-> The kit will most likely be the standard no-fault type. Depending on
-> requirements, System A and/or System B can be used. When operating System A,
-> depress lever and a plastic dalkron unsubscriber will be dispensed through
-> the slot immediately underneath. When you have fastened the adhesive lip,
-> attach connection marked by the large "X" outlet hose. Twist the silver-
-> coloured ring one inch below the connection point until you feel it lock.
->
-> The kit is now ready for use. The Cin-Eliminator is activated by the small
-> switch on the lip. When securing, twist the ring back to its initial
-> condition, so that the two orange lines meet. Disconnect. Place the dalkron
-> unsubscriber in the vacuum receptacle to the rear. Activate by pressing the
-> blue button.
->
-> The controls for System B are located on the opposite side. The red release
-> switch places the Cin-Eliminator into position; it can be adjusted manually
-> up or down by pressing the blue manual release button. The opening is self-
-> adjusting. To secure after use, press the green button, which simultaneously
-> activates the evaporator and returns the Cin-Eliminator to its storage
-> position.
->
-> You may log off if the green exit light is on over the evaporator . If the
-> red light is illuminated, one of the Cin-Eliminator requirements has not been
-> properly implemented. Press the "List Guy" call button on the right of the
-> evaporator . He will secure all facilities from his control panel.
->
-> To use the Auto-Unsub, first undress and place all your clothes in the
-> clothes rack. Put on the velcro slippers located in the cabinet immediately
-> below. Enter the shower, taking the entire kit with you. On the control panel
-> to your upper right upon entering you will see a "Shower seal" button. Press
-> to activate. A green light will then be illuminated immediately below. On the
-> intensity knob, select the desired setting. Now depress the Auto-Unsub
-> activation lever. Bathe normally.
->
-> The Auto-Unsub will automatically go off after three minutes unless you
-> activate the "Manual off" override switch by flipping it up. When you are
-> ready to leave, press the blue "Shower seal" release button. The door will
-> open and you may leave. Please remove the velcro slippers and place them in
-> their container.
->
-> If you prefer the ultrasonic log-off mode, press the indicated blue button.
-> When the twin panels open, pull forward by rings A & B. The knob to the left,
-> just below the blue light, has three settings, low, medium or high. For
-> normal use, the medium setting is suggested.
->
-> After these settings have been made, you can activate the device by switching
-> to the "ON" position the clearly marked red switch. If during the
-> unsubscribing operation, you wish to change the settings, place the "manual
-> off" override switch in the "OFF" position. You may now make the change and
-> repeat the cycle. When the green exit light goes on, you may log off and have
-> lunch. Please close the door behind you.
->
-> -Dave
->
_______
Lukasz Gogolewski - [EMAIL PROTECTED]
Tel: 347.452.6837 - Fax: 718.504.4822
SupremeDesigns - www.supremedesigns.com
