did you compile qmailadmin after installing both ezmlm and ezmlm-idx?? reinstall qmailadmin from scratch, remove old qmailadmin-1.0.6 and start with new qmailadmin dir or perhaps a make clean will work
regards, marco leeflang leeflang-it On Sun, 2002-12-29 at 00:56, Aurora Solutions Support wrote: > Sorry if this has been asked before. I have searched the mailing > list archive and could not see an answer so I'm going to ask my > question here. On the qmailadmin's demo site, there is a lovely > lot of options for configuring mailing lists. I have spent the > past 3 hours trying to configure ezmlm, ezmlm-idx, and qmailadmin > to produce these features, and try as I might I have not done it, > I can only get 4 options - Archived / Not Archived & Respond to > / Allow only digest creation. > > So far, I have downloaded ezmlm-0.53.tar.gz and > ezmlm-idx-0.40.tar.gz. I have extracted both and copied the > contents of ezmlm-idx-0.40 to ezmlm-0.53 and applied the patch > via 'patch < idx.patch'. I then ran 'make', 'make man', and > finally 'make setup'. > > qmailadmin compiled fine and works. > > Can anyone tell me where I've gone wrong please. > > Many thanks, > --- > Stuart O'Reilly > > System Spec:- > -- > > 1.1Ghz AMD Athlon > 512MB Memory > 60GB IBM Desktop HDD > Slackware 8.1 > >
