before install the patch don't make and install the ezmlm. tar zxvf ezmlm-0.53.tar.gz tar zxvf ezmlm-idx-0.40.tar.gz. mv ezmlm-idx.0.40/* ezmlm-0.53/ cd ezmlm-0.53 patch < idx.patch make clean make make install
after this untar the qmailadmin-1.06 ./configure make make install works for me, marco leeflang leeflang-it On Sun, 2002-12-29 at 02:15, Stuart O'Reilly wrote: > Right, here is what I have just done: > > Downloaded ezmlm-0.53.tar.gz. Unzipped it, run 'make' 'make man' & > 'make setup' on it. Tested it by following the procedures listed for > creating a testlist. All worked. I then downloaded > ezmlm-idx-0.40.tar.gz and copied it's contents into the ezmlm-0.53 > directory and ran 'patch < idx.patch'. I then proceeded to run 'make', > 'make man', and 'make setup' again. After which I tested the ezmlm setup > by creating another list as described in the install doc. This all > worked out. I then proceeded to install qmailadmin-1.06.tar.gz which > went without a problem. > > I then loaded it up on my website, and when I clicked 'New mailing list' > I still only have the four options I described earlier. > > Previous to this install, I had removed all relevant files. > > --- > Stuart O'Reilly > > -----Original Message----- > From: Marco Leeflang [mailto:[EMAIL PROTECTED]] > Sent: 29 December 2002 00:28 > To: [EMAIL PROTECTED] > Subject: Re: [qmailadmin] qmailadmin & ezmlm-idx > > did you compile qmailadmin after installing both ezmlm and ezmlm-idx?? > reinstall qmailadmin from scratch, remove old qmailadmin-1.0.6 and start > with new qmailadmin dir or perhaps a make clean will work > > regards, > marco leeflang > leeflang-it > > > > On Sun, 2002-12-29 at 00:56, Aurora Solutions Support wrote: > > Sorry if this has been asked before. I have searched the mailing > > list archive and could not see an answer so I'm going to ask my > > question here. On the qmailadmin's demo site, there is a lovely > > lot of options for configuring mailing lists. I have spent the > > past 3 hours trying to configure ezmlm, ezmlm-idx, and qmailadmin > > to produce these features, and try as I might I have not done it, > > I can only get 4 options - Archived / Not Archived & Respond to > > / Allow only digest creation. > > > > So far, I have downloaded ezmlm-0.53.tar.gz and > > ezmlm-idx-0.40.tar.gz. I have extracted both and copied the > > contents of ezmlm-idx-0.40 to ezmlm-0.53 and applied the patch > > via 'patch < idx.patch'. I then ran 'make', 'make man', and > > finally 'make setup'. > > > > qmailadmin compiled fine and works. > > > > Can anyone tell me where I've gone wrong please. > > > > Many thanks, > > --- > > Stuart O'Reilly > > > > System Spec:- > > -- > > > > 1.1Ghz AMD Athlon > > 512MB Memory > > 60GB IBM Desktop HDD > > Slackware 8.1 > > > > > > > > > > > >
