If it will happily run at that speed and oil pressure is ok, then it should be 
fine.  Initially I had my zetec ticking over 500-600 rpm.  I've upped that 
quite bit now tho to 1krpm.

Matthew



-----Original Message-----
From: IanH (S3-023) <[email protected]>
Sent: 27 January 2009 11:20
To: Quantum Owners Group <[email protected]>
Subject: [Quantum Owners] Re: New cam fitted

Good job. It's always nice to get things going again when you have
made significant changes.

Is 800rpm on the low side for an engine with a more lumpy cam? I think
my pinto should idle at 850 - 1150 with it's 285 cam.

Ian

On Jan 26, 10:15 pm, Bob Craig <[email protected]> wrote:
> finally it stopped raining long enough for me to get the car outside
> and get the front end back on. Took it for a test. Pretty happy with
> the new cam (CVH22). No drop off at low revs but now has much more
> poke higher up and pulls all the way to the red line.
>
> On 19 Jan, 22:29, Bob Craig <[email protected]> wrote:
>
> > Put a new rotor arm on - the old one was quite badly burnt. Also went
> > back to basics with the carb set up and made sure the throttle cable
> > was correctly adjusted Now running very nicely and ticking over at
> > 800rpm, Need to get the front end back on and give it a road test but
> > can't get it out of the garage for log enough due to the rain and snow
>
> > On 17 Jan, 22:32, Bob Craig <[email protected]> wrote:
>
> > > Finally got round to fitting my Kent cam today. It's a long time since
> > > I had done one , so was a bit apprehensive, particularly as it was not
> > > a standard one and required a bit more care in setting it up. It was a
> > > relief when it started first time. Still needs a bit of fine tuning
> > > with the vernier pulley and maybe a a tweek of the ignition timing but
> > > so far so good
>
> > > Anyone who has one already fitted - what have you set your ignition
> > > timing at?
>
> > > Bob Craig (Q2-267)- Hide quoted text -
>
> > - Show quoted text -



--~--~---------~--~----~------------~-------~--~----~
  You received this message because you are subscribed to the Google Groups 
"Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/quantumowners?hl=en

IMPORTANT NOTE: All information presented herewith is provided on an "As Is" 
basis, without warranty or the implication thereof. Neither the Quantum Owners 
Club nor the individuals associated with the Quantum Owners Club or in the 
preparation of the above information shall have any liability to any person or 
entity with respect to liability, loss, or damage caused or alleged to be 
caused directly or indirectly by the instructions contained within this or 
related message(s).
-~----------~----~----~----~------~----~------~--~---

Reply via email to