Thats an interesting one.
There is only one wire to the starter to turn it over, the wire powers 
up the solenoid on the starter which both engages the starter with the 
flywheel and connects the power to the starter motor itself.
Think of the solenoid as a relay for the starter power plus it moves the 
gear into mesh.

So, if the starter motor is spinning but it's not turning the engine 
over it's one of 2 things.
Either there is a short on the starter solenoid between the 2 big 
terminals or there is power to the small terminal on the starter but 
it's not a high enough voltage to pull the solenoid far enough for it to 
engage with the ring gear.

The easiest test is to pull the small wire off the starter solenoid 
while this problem is occurring (the starter is spinning).
If the starter keeps going then it's the first cause and if it keeps 
going it's the second.

If it keeps going check that the 2 big wires aren't shorting, there is a 
plastic "bridge" moulded into the solenoid to stop this but it often 
breaks away and the wires can short. Otherwise it must be internal to 
the solenoid.

If it stops then go back to the ignition switch, does the starter stop 
spinning if you unplug the ignition switch connector ?, if so it could 
be a fault ignition switch.
In between that is just the immobiliser and maybe a link in the fuse 
box, check for a relay position with a metal link fitted instead of a 
relay (this has a relay that disables the starter on a car with a auto 
gearbox). If you have the link it could be  a short inside the fusebox.

Jim


Steve Kodz wrote:
> This is now the second starter motor where I've had this problem, so I'm 
> starting to think it's the car and not the starter.
>
> With the battery connected and no ignition power the starter motor runs 
> constantly - the only way to stop it is to disconnect the battery.  The 
> starter is not engaging the flywheel, so it's not trying to turn over the 
> engine.  It had been running fine for about half a day before this and the 
> only common thing with the previous starter is that both hadn't been on the 
> car that long and showed the problem after the engine got hot, however I 
> now have the current starter wrapped in a flexible head shield.
>
> There is an immobiliser on the car that immobilises the starter motor as one 
> of the 2 circuits, so could this potentially be the cause?
>
> The car is my H4 with it's CVH turbo engine using the EFi management from 
> the FRST donor.
>
> Any help will be appreciated as I need to sort this out to get the car to 
> it's MoT retest next week - it only failed because the rear brake cylinders 
> had seized, which wasn't bad seeing the car hadn't moved since may!
>
> Regards,
> Steve
>   


--~--~---------~--~----~------------~-------~--~----~
  You received this message because you are subscribed to the Google Groups 
"Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/quantumowners?hl=en

IMPORTANT NOTE: All information presented herewith is provided on an "As Is" 
basis, without warranty or the implication thereof. Neither the Quantum Owners 
Club nor the individuals associated with the Quantum Owners Club or in the 
preparation of the above information shall have any liability to any person or 
entity with respect to liability, loss, or damage caused or alleged to be 
caused directly or indirectly by the instructions contained within this or 
related message(s).
-~----------~----~----~----~------~----~------~--~---

Reply via email to