It's the void between the outside of the wing, the door pillar and the
face of the steel box section.
The open side of this is covered with a trapezoid shaped flat bit of
fibreglass bonded in.
Then the inside is covered with rubber compound but quite often it
doesn't totally seal, especially in the corner where the horizontal
section of the steel tube goes under the door sill and the water then
runs round the tube and comes out in the car.
I presume you'd seen the bit on my web site.
Jim
On 28/11/2010 10:18, jin wrote:
hi all, quick question regarding waterproofing the 2+2,
the area around the door hinges that can leak into the car, when a
"pocket" is described, is it a seperate cup shapped panel bonded
behind the door hinges internally to encase them or is it the void
created by fiberglassing the steel sill section in and making the A
post and front inner wheelarch?
cheers for any help
--
You received this message because you are subscribed to the Google Groups "Quantum
Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an "As Is"
basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor
the individuals associated with the Quantum Owners Club or in the preparation of the
above information shall have any liability to any person or entity with respect to
liability, loss, or damage caused or alleged to be caused directly or indirectly by the
instructions contained within this or related message(s).
