On the zetec Xtreme installation, there is no space for a temp sensor on old thermostat housing which is where the raceline bolts on as there is no clearance to the bulkhead. The intermediate position is used for a T piece connected to the water temp sensor and heater hose. Thus leaving the tstat housing for the cooling fan temp sensor.
I will check mine later to see if can help. What about buying from Burton Power who sell Raceline or Raceline themselves. Out of interest have you checked yours? I have found on mine that the tstat housing is very high and if the water level is down ie expansion tsnk below the sensor the fan performance gets erratic or doesn't work. I assume due to an air lock. Regards Nigel -- -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to quantumowners@googlegroups.com To unsubscribe from this group, send email to quantumowners-unsubscr...@googlegroups.com For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). --- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To unsubscribe from this group and stop receiving emails from it, send an email to quantumowners+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.
