Corinna Thanks for the suggestion. I can not duplicate the error myself. I generally have a code segment open in Tinn-R and have sent it to R and wish to rerun it with some changes but when I try to make the changes they are transferred to the line above one character per line. This has happened about 5/6 times since Christmas. The code segments were different. I can think of no common factor that might have caused the problem. Closing tinn-r and R and restarting always cured the problem which then did not occur again for several days and in different circumstances. I have not looked for help because I have been unable to replicate the problem.
John Frain On 11/02/2008, Schmitt, Corinna <[EMAIL PROTECTED]> wrote: > > > > Hallo, > > I had the same problems before. I think the best solution is that you just > copy the needed codepart out of Tinn-R with Ctr+C. Then open R directly from > your desktop NOT from Tinn-R. Than paste in the command. you can still make > changes in the command when you have not pressed enter by using the arrow > buttons of the keyboard. put the curse where you want in the command line > and change it. > > Hope that is what you want. I cannot imitate your example. > > Corinna > > > -- John C Frain Trinity College Dublin Dublin 2 Ireland www.tcd.ie/Economics/staff/frainj/home.html mailto:[EMAIL PROTECTED] mailto:[EMAIL PROTECTED] ______________________________________________ R-help@r-project.org mailing list https://stat.ethz.ch/mailman/listinfo/r-help PLEASE do read the posting guide http://www.R-project.org/posting-guide.html and provide commented, minimal, self-contained, reproducible code.