Thanks Piegorsh, I did it..
NOPIPE=yes ./rancid -d -t cisco 172.17.1.6 but in the two file 172.17.1.6.new and 172.17.1.6.raw don't see anything about this error. both show the correct command output. On Wed, Jul 3, 2019 at 11:29 AM Piegorsch, Weylin William <wey...@bu.edu> wrote: > If you do the “NOPIPE” thing and run rancid with the -d flag, that will > create two files: .new, and .raw. Examine the .raw file, which is the > byte-for-byte capture of the CLI session. > > weylin > > > > *From: *Kevin Morales <kevin.mora...@gmail.com> > *Date: *Wednesday, July 3, 2019 at 1:24 PM > *To: *john heasley <h...@shrubbery.net> > *Cc: *Nick Nauwelaerts <nick.nauwelae...@aquafin.be>, Weylin Piegorsch < > wey...@bu.edu>, "rancid-discuss@shrubbery.net" < > rancid-discuss@shrubbery.net> > *Subject: *Re: [rancid] Unable to figure out "end of run not found" > > > > ok, but rancid do not save the output of command., > > > > How I can fix this problem? > > > > On Wed, Jul 3, 2019 at 11:12 AM john heasley <h...@shrubbery.net> wrote: > > Wed, Jul 03, 2019 at 07:48:09AM -0600, Kevin Morales: > > Hello!, > > > > How I can fix the problem when I run rancid for ZTE Router?. I get this > > error: *End of run not found* > > > > the two file 172.17.1.6.new and 172.17.1.6.raw don't show any error!. > > > > NOPIPE=yes ./rancid -d -t cisco 172.17.1.6 > > > > loadtype: device type cisco > > loadtype: found device type cisco in > /usr/local/rancid/etc/rancid.types.base > > executing clogin -t 90 -c"show version;show install active;show vlan;show > > running-config" 172.17.1.6 > > PROMPT MATCH: RT-ZTE# > > HIT COMMAND: RT-ZTE #show version > > In ShowVersion: RT-ZTE #show version > > HIT COMMAND: RT-ZTE #show install active > > In ShowInstallActive: RT-ZTE #show install active > > HIT COMMAND: RT-ZTE #show vlan > > In ShowVLAN: RT-ZTE #show vlan > > HIT COMMAND: RT-ZTE #show running-config > > In WriteTerm: RT-ZTE #show running-config > > *172.17.1.6 <http://172.17.1.6>: End of run not found* > > 172.17.1.6: clean_run is false > > 172.17.1.6: found_end is false > > !</isis> > > found end means that it found the end of the config; for type cisco, > that means "^end". > > clean run means that it found the cli logout; for type cisco, that > means "prompt[>#] exit$" > > > > > -- > > *Kevin Morales* > -- *Kevin Morales*
_______________________________________________ Rancid-discuss mailing list Rancid-discuss@shrubbery.net http://www.shrubbery.net/mailman/listinfo/rancid-discuss