If these bikes are drop bar setups with exact same saddle and bars and hoods, measure these measurements of the bike you want to duplicate in cm: Saddle setup: 1.Seat height 2.Seat tilt 3.Seat nose fore/aft to center of stem bolt measurement Last, 4.Saddle height from floor to saddle top Bar/stem setup: 5.Drop bar tops from floor to bar tops measured at close to the stem clamp. 6.Seat nose fore/aft to deepest part of brake hoods (along the inside curve where your hand rests on the hood.). Note tilt of bars on reference bike before measuring and recreate. If profile shows bar ramps in line with stem extension, etc. #6 is the last thing you do once you get the bar height and tilt done. Get the left lever in place where you want it, remove bars and level them by getting the right lever adjusted with a table as reference like in the RBW handlebar setup video. Then reinstall at the correct bar to saddle height.
Combining the results of 4 and 5 gets you your bar height to saddle measurement to see how many cm below or above saddle your bars are. Measurements of saddle and bar height from floor must be taken with bike in same upright position for accuracy. Adjusting hoods, individually moving them up or down along ramps to duplicate 6 can be tough. Recreating these saddle and stem/bar measurements can be frustrating and a balancing act. Set up the saddle measurements first. The do bar tilt, height, and hoods last. Make sure the stem bolt is tight or your #3 measurement will be off. -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To unsubscribe from this group and stop receiving emails from it, send an email to rbw-owners-bunch+unsubscr...@googlegroups.com. To post to this group, send email to rbw-owners-bunch@googlegroups.com. Visit this group at https://groups.google.com/group/rbw-owners-bunch. For more options, visit https://groups.google.com/d/optout.