Jay,
When you say the skewer is too wide, are you referring to the diameter of
the skewer being too big around to slide through the hole in the axle or are
you saying that even with the nut screwed all the way down on the skewer it
won't close tight enough when you clamp down the quick release lever?
If it's the former, is there a burr or some other issue obstructing the hole
drilled through the axle?
Have you looked through it with a bright light?
Is the axle bent and the sewer can't go all the way through?
If the latter, is it possible the skewer was not threaded far enough to
properly cinch down?
Is it possible you have inadvertently tried a rear quick release instead of a
front?
Ray
Vallejo CA
--
You received this message because you are subscribed to the Google Groups "RBW
Owners Bunch" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to rbw-owners-bunch+unsubscr...@googlegroups.com.
To post to this group, send email to rbw-owners-bunch@googlegroups.com.
Visit this group at https://groups.google.com/group/rbw-owners-bunch.
For more options, visit https://groups.google.com/d/optout.
