Glad to hear. It was ony a few minute break at work here. Chrys ----- Original Message ----- From: "Joker" <[EMAIL PROTECTED]> To: "R/C Tank Combat" <rctankcombat@googlegroups.com> Sent: Tuesday, December 09, 2008 11:17 PM Subject: [TANKS] Re: Drive Cog Patterns
> > Thanks. This was great. I took the photo, scalled it, inverted the > colors, and i'm using it as the template. Thanks again. > > On Dec 8, 4:41 am, "Chrysanthos Kanellopoulos" <[EMAIL PROTECTED]> > wrote: > > The diameter of the inner circle (green) could be 0.0873, with the clear > > distance between the teeth 0.0350 = 1 3/8". That way, the pads fit between > > the teeth. > > The width of the tooth ~ 0.064 or 0.0638 m. or 1/4" wide. > > The diameter of the outer circle, on the edge of the teeth would then be > > 0.0993 m. = 3,901 " > > I hope that helps and it is not more confusing! > > > > Chrys > > > > JOkers sprocket7.3.jpg > > 123KViewDownload > > > > JOkers sprocket7.4.jpg > > 66KViewDownload > > > > > > __________ NOD32 3434 (20080911) Information __________ > > This message was checked by NOD32 antivirus system. > http://www.eset.com > > --~--~---------~--~----~------------~-------~--~----~ You are currently subscribed to the "R/C Tank Combat" group. To post a message, send email to rctankcombat@googlegroups.com To unsubscribe, send email to [EMAIL PROTECTED] Visit the group at http://groups.google.com/group/rctankcombat -~----------~----~----~----~------~----~------~--~---
