well its been a while but all the parts for my system have been purchased and have arrived. unpacked everything and put the mass of it together and tested it. my vantec 23 i guess couldnt take the heat because i hooked it up and was working fine until i made a change in the orientation of a few wires so the motors would rotate in the same direction. i guess this change brought about by cause was a stupid decision because white smoke emerged from my precious several weeks of work machine. i have no idea how to fix it and no hope that it can be fixed, this project has finally run me dry and i no longer want to put up with this. i have no want left in me to purchase another and if i did i would buy the most expensive esc in hopes the amperage would not break it... if there are any ways any one could assist in telling me the excact cause of the smoke it would be much appreciated.
-- You are currently subscribed to the "R/C Tank Combat" group. To post a message, send email to [email protected] To unsubscribe, send email to [email protected] Visit the group at http://groups.google.com/group/rctankcombat
