Larry, As you may remember from an earlier post, the Magnum also wouldn't run a Buderus hydronic boiler. Follow up testing never happened, so I have no more info, as once a Lochinvar boiler was installed the problem ended, and everyone else involved went home.
Allan Sindelar al...@positiveenergysolar.com NABCEP Certified Photovoltaic Installer EE98J Journeyman Electrician Positive Energy, Inc. 3201 Calle Marie Santa Fe, New Mexico 87507 505 424-1112 www.positiveenergysolar.comHi Jeff, I am not sure if this relates to your issue but there is an issue with Magnum inverters and Splindide washers. Splindide will not work on a Magnum sine wave. They are aware of this. Here is a copy of my old post to the list: ....I have a recent power issue come up with a Magnum inverter. A customer tried to operate her Splindide washer/dryer but the motor would not start. I looked at the waveform with a scope and RMS voltage and frequency were fine. The waveform looked good until the motor tried to start. The washer was putting a jagged noise riding on the sine wave. The voltage and waveform still looked OK other than the noise. I was mostly sure that this was the cause so I grabbed a 600 watt cheap import sine wave inverter and connected the washer. Same ripple was present on the waveform but the $400 inverter would run the washer motor fine. It also runs fine with a 1600 watt Honda inverter/generator. Larry Crutcher Starlight Solar (928) 941-1660 Renewable Energy Products, Service and Installation
_______________________________________________ List sponsored by Home Power magazine List Address: RE-wrenches@lists.re-wrenches.org Options & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out participant bios: www.members.re-wrenches.org