With Solarworld/SnapNRack we run wires in the rail and use clips on the long edge of the frame when needed. SnapNRack has a clip that fits in the upper rail groove to hold wires down into it. The snap n rack part you are referencing (I think they call it 'box frame adapter') is good if you want to attach squirrel netting to the short edge of the panels, but it's bulky and expensive. I don't think it will do much for attaching wire clips. Adam
On Wed, May 24, 2017 at 8:11 AM Dana <d...@solarwork.com> wrote: > I am installing SolarWorld 285 w modules for our new home on Array > Technologies dual axis trackers [we are in a canyon]. > > The side rails of the frames are typical with a flange however the short > end frame is this little kind of “I” beam that does not allow for any wire > clips. > > I am wondering what other folks have done in this situation, short of > drilling the module frame? > > SnapnRack has a ¾” thick clamp that creates a 7/8” min gap between the > module columns that is rather unsightly. > > Suggestions? > > > > > ---------------------------------------------------------------------------- > > Dana Orzel Great Solar Works, Inc. > > *208.721.7003 d...@solarwork.com > <d...@solarwork.com>* > > Idaho Contractor - # 028765 Idaho PV # 028374 > > NABCEP # 051112-136 www.solarwork.biz > > *"Responsible Technologies for Responsible People since 1988" * > > *P* Please consider the environment before printing this email. > > > > > _______________________________________________ > List sponsored by Redwood Alliance > > List Address: RE-wrenches@lists.re-wrenches.org > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > List-Archive: > http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html > > List rules & etiquette: > www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > www.members.re-wrenches.org > > -- Adam Katzman Autonomous Energies PO Box 1245 Kingston, NY 12402 www.autonomousenergies.com (518) 567-1468
_______________________________________________ List sponsored by Redwood Alliance List Address: RE-wrenches@lists.re-wrenches.org Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out or update participant bios: www.members.re-wrenches.org
