I have the same hardware, and just recently got it to work. first of all I
believe your kernel arg is incorrect. I assume you're giving this argument as
an 'append' statement in your lilo.conf file. the line breaks down something
like this:
append="aha152x=<io addr>,<irq>,<scsi id>,<something I don't remember, but is
a 1>"
the io address is set on the card, and is either 0x140 or 0x340. you probably
have the correct address. irq is also set on the card, as you probably know,
and have set correctly. the scsi id should be for the zoom card, NOT the zip
drive. IIRC, the scsi id for the card is 7, and you probably have the drive
set to 5. the last argument is some type of read/write or mount/umount
option, I don't recall, but should be a one. therefore, you're new append
statement should look something like this:
append="aha152x=0x140,9,7,1" (don't forget to re-run lilo!)
I also recompiled the kernel with scsi as a module. this next trick is to
mount the correct scsi device. for some reason, on MS-DOS disks, you must
mount /dev/sda4. linux will then automagically load the scsi modules, and you
should be able to read the drive.
hop this helps.
Pat
ps- check out the scsi HOWTO along with your zip HOWTO
> I have a SCSI Zip Drive on one of those single-chip no-bios 8-bit Zip
> Zoom SCSI controllers. I know the IRQ, the memory location, and the
> SCSI ID, so the line should read aha152x=0x140,9,5, but no matter, I
> still can't get the blessed thing to even recognize that there is a scsi
> system installed. The HOWTO seems to be concerned primarily with par
> port and IDE/ATAPI ZIPs.
******************************************************
Patrick M. Ferdig [EMAIL PROTECTED]
Consultant, Iowa State University Computation Center
Programmer, ISU Ag & Biosystems Engineering Dept.
http://www.public.iastate.edu/~pferdig/
******************************************************
--
PLEASE read the Red Hat FAQ, Tips, Errata and the MAILING LIST ARCHIVES!
http://www.redhat.com/RedHat-FAQ /RedHat-Errata /RedHat-Tips /mailing-lists
To unsubscribe: mail [EMAIL PROTECTED] with
"unsubscribe" as the Subject.