>Hi folks,
<snip>
>Scenario:
>All peripherals are *on*, I boot off the floppy and the install picks up
>the controller as a 2940, usually takes a few tries to get the SCSI >cdrom
>(and only the Ricoh..probably because it's SCSI ID is first) and
>everything
>starts out OK. It recognizes both disk drives and the ZIP and the Jaz.
>I'm installing on an extended partition of the first (6.4 HDD). I
>partition with fdisk and when I try to write the partition (option"w") it
>says it can't read and that I should reboot making sure that there are
>disks in the Jaz and ZIP drives.
>When I do this I get all the way to the point where it scans the drives
>"Scanning Hard Drives" (presumably to get the partition info) and >the
>install blows up with a "Signal 11 received"...system shut down, etc.
>I have subsequently tried multiple permutations....terminating the >chain
on
>the scanner (so no Jaz or Zip seen), etc...everything I can think of >and I
>get no further.
>Any and all help would be greatly appreciated!
>regards,
>Jil
Try disabling your processor cache. Sig 11 is most of the time a cache
problem.
Best option is to disable L1 and L2 cache.
Igmar
--
PLEASE read the Red Hat FAQ, Tips, Errata and the MAILING LIST ARCHIVES!
http://www.redhat.com/RedHat-FAQ /RedHat-Errata /RedHat-Tips /mailing-lists
To unsubscribe: mail [EMAIL PROTECTED] with
"unsubscribe" as the Subject.
