Here is what I get with hdpram. I suspect it is a flaky hard drive. For one
thing
I scrambled the drive when it was brand new with Partition Magic. However it
has been relatively well behaved for 6 months of use with only an occasional
drive reset message in the logs until 2 weeks ago. It had a bad video card
when I tried the orginal set up it is one of the reasons I kept it at home
for developmental work instead of using it for a server. Some machines are
just untrustworthy.

output /sbin/hdparm -i /dev/hda

/dev/hda:

 Model=ST36421A, FwRev=8.01, SerialNo=6BE051YR
 Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs RotSpdTol>.5% }
 RawCHS=13330/15/63, TrkSize=0, SectSize=0, ECCbytes=4
 BuffType=0(?), BuffSize=256kB, MaxMultSect=16, MultSect=off
 DblWordIO=no, maxPIO=2(fast), DMA=yes, maxDMA=2(fast)
 CurCHS=784/255/63, CurSects=913440960, LBA=yes, LBAsects=12596850
 tDMA={min:120,rec:120}, DMA modes: mword0 mword1 *mword2
 IORDY=on/off, tPIO={min:240,w/IORDY:120}, PIO modes: mode3 mode4

output /sbin/hdparm -v /dev/hda

/dev/hda:
 multcount    =  0 (off)
 I/O support  =  0 (default 16-bit)
 unmaskirq    =  0 (off)
 using_dma    =  0 (off)
 keepsettings =  0 (off)
 nowerr       =  0 (off)
 readonly     =  0 (off)
 readahead    =  8 (on)
 geometry     = 784/255/63, sectors = 12596850, start = 0
                       Thanks
                       Linda.


-- 
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.

Reply via email to