I've had fairly good luck with low-level formatting Seagate drives (I use 
their DOS app so you have to have a DOS boot disk)... but enormous new 
drives are so cheap, and your time/data so precious that I would consider a 
new drive if you "suspect it is a flaky drive".

-Alan

At 02:31 PM 5/3/00 , you wrote:
>Here is what I get with hdpram. I suspect it is a flaky hard drive. For one
>thing
>I scrambled the drive when it was brand new with Partition Magic. However it
>has been relatively well behaved for 6 months of use with only an occasional
>drive reset message in the logs until 2 weeks ago. It had a bad video card
>when I tried the orginal set up it is one of the reasons I kept it at home
>for developmental work instead of using it for a server. Some machines are
>just untrustworthy.
>
>output /sbin/hdparm -i /dev/hda
>
>/dev/hda:
>
>  Model=ST36421A, FwRev=8.01, SerialNo=6BE051YR
>  Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs RotSpdTol>.5% }
>  RawCHS=13330/15/63, TrkSize=0, SectSize=0, ECCbytes=4
>  BuffType=0(?), BuffSize=256kB, MaxMultSect=16, MultSect=off
>  DblWordIO=no, maxPIO=2(fast), DMA=yes, maxDMA=2(fast)
>  CurCHS=784/255/63, CurSects=913440960, LBA=yes, LBAsects=12596850
>  tDMA={min:120,rec:120}, DMA modes: mword0 mword1 *mword2
>  IORDY=on/off, tPIO={min:240,w/IORDY:120}, PIO modes: mode3 mode4
>
>output /sbin/hdparm -v /dev/hda
>
>/dev/hda:
>  multcount    =  0 (off)
>  I/O support  =  0 (default 16-bit)
>  unmaskirq    =  0 (off)
>  using_dma    =  0 (off)
>  keepsettings =  0 (off)
>  nowerr       =  0 (off)
>  readonly     =  0 (off)
>  readahead    =  8 (on)
>  geometry     = 784/255/63, sectors = 12596850, start = 0
>                        Thanks
>                        Linda.
>
>
>--
>To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
>as the Subject.


-- 
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.

Reply via email to