I'm going out on a limb on this one, because lilo and linux booting isn't
my forte (hmm... I seem to have forgotten what was), but comparing this
with other issues that I've expereinced I'll guess that you need to set up
a startup RAM disk.
If my guessing is right, RedHat moved away from RAM disk use (initrd) by
default in kernels 2.2.14 and 2.2.16 (RedHat 6.2) where it had been present
in 2.2.12 (RH 6.1). So, I think you need to make a RAM disk (initrd).
Since I'm using the 6.1 installer (and upgrading RPMs and source compiling
from there) I can't explain or describe how to do that, but I do remember
seeing HOW-TO docs at linuxdoc.
Lee Howard
At 03:10 PM 7/23/00 -0500, you wrote:
>
>I have a Compaq (I know, I know. It wasn't my choice!) Proliant ML-370
>server with an ICP Vortex GDT60518RS RAID controller installed, connected
>to 5 9GB drives.
>
>I am trying to install Red Hat 6.2 on this machine, using the ICP Vortex
>controller's BIOS to set up a RAID 5 array, using 4 of the drives, and one
>drive as a hot spare. The logic here is that Linux should see this array
>as one large disk, with all the RAID minutiae handled from the Vortex
>card.
>
>When setting up Red Hat 6.2, I can use the expert mode to detect the RAID
>controller, and install goes fine.
>
>However, the machine will only boot from the boot floppy.
>
>Does anyone have experience with a similar setup? Any pointers to help me
>boot this machine from LILO instead of a floppy would be great.
>
>Thanks!
>
>--
>Chuck Milam
>[EMAIL PROTECTED]
>
>
>
>
>--
>To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
>as the Subject.
>
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.