Chuck Milam wrote:
> 
> I have a Compaq (I know, I know.  It wasn't my choice!) Proliant ML-370
> server with an ICP Vortex GDT60518RS RAID controller installed, connected
> to 5 9GB drives.
> 
> I am trying to install Red Hat 6.2 on this machine, using the ICP Vortex
> controller's BIOS to set up a RAID 5 array, using 4 of the drives, and one
> drive as a hot spare.  The logic here is that Linux should see this array
> as one large disk, with all the RAID minutiae handled from the Vortex
> card.
> 
> When setting up Red Hat 6.2, I can use the expert mode to detect the RAID
> controller, and install goes fine.
> 
> However, the machine will only boot from the boot floppy.
> 
> Does anyone have experience with a similar setup?  Any pointers to help me
> boot this machine from LILO instead of a floppy would be great.
> 
> Thanks!
> 
> --

Yes, but with a Mylex AcceleRaid controller, not a Vortex, but it shouldn't
make any difference.  First, because the >logical< drive is so big, >1024 
cylinders, you need to set up a /boot partition seperate from the /root
partition.
Next, make sure the Lilo configuration is correct.  This is the problem I had.  

Here's what I'm using:

boot=/dev/rd/c0d0                      # This is the Logical drive
map=/boot/map
install=/boot/boot.b
serial = 0,9600n8
prompt
timeout=50
linear
message=/etc/lilo.message

image=/boot/vmlinuz-2.2.16
   label=l2216
   append="console=ttyS0,9600"
   read-only
   root=/dev/rd/c0d0p5                # This is the /root partitio              
....

Note that the /boot partition is /dev/rd/c0d0p1, but that doesn't come into
play with lilo.  But be sure that the /etc/fstab file is correct for /boot

I suggest you boot up, check the lilo config and rerun lilo.  If you didn't
make a seperate /boot parition 1st, the I think you need to start over.

Cokey

-- 
------------------------------------------------------------------
Cokey de Percin, DBA            Email:
Policy Management Systems Corp.  Work - [EMAIL PROTECTED]
Columbia, South Carolina         Home - [EMAIL PROTECTED]


-- 
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.

Reply via email to