On Tue, 10 Oct 2000, James wrote:

> I've been having a very puzzling problem setting up a home LAN.
> 
> I can ping localhost, and I can ping my ethernet card without problems.  I
> have swapped out the card itself, changed IRQ & IO address, and checked the
> cable and hub.  Right now the card is a WD8013.
> 
> I'm only trying to get two machines to talk to each other via ethernet, so
> my routing table is very short and sweet.
> 
> /sbin/route -n
> 
> DESTINATION    GW           MASK                  FLAGS  METRIC .... DEV
> 192.168.0.2        192.168.0.1  255.255.255.255    UGH    1              ...
> eth0
> 192.168.0.0        192.168.0.1  255.255.255.0        UG       1
> ... eth0
> 127.0.0.1                0.0.0.0       255.0.0.0               U          0
> ... lo
> 
> (as you can see I typed it instead of cat - this is being typed on my Win98
> box)
> 
> My Linux box (was RH6.2, now RH7.0) is 192.168.0.1, the Win98 box I want to
> ping is 192.168.0.2.  When I ping the Win98 box I get this error:
> 
> ping 192.168.0.2 -n
> (the -n switch forces ping to use the numeric address, instead of trying to
> find an alias)
> 
> PING 192.168.0.2 FROM 192.168.0.1:
> >From (192.168.0.1):  Destination Host Unreachable
> 
> Since my routing table looks good to me, /etc/hosts has the correct entries
> and I test numerically anyway, the only thing that I can think of is that
> there is a resource conflict with the card somewhere.
> 
Your routing table doesn't look good to me.  To get anywhere except
localhost, your table says you have to go through 192.168.0.1.  You should
have a gateway address of 0.0.0.0 instead of 192.168.0.1.  This is why you
are getting the Destination Host Unreachable error.
>
> But if I cat /proc/interrupts I don't get a full list of IRQs.  cat
> /proc/pci fills in some of the missing numbers but not all of them.  I also
> have a modem on this machine which is jumpered to IRQ 3, and I don't see
> that IRQ listed anywhere (even though my ethernet card shows up in
> /proc/interrupts).  Is there another place to find a list of ALL of the
> IRQs?
> 
You will not see the interupt used by the modem unless you have a program
actualy using the modem.  The interupt is not being used when the modem is
not in use.  /proc/interrupts is a dynamic listing.
>
> And where can I find a list of I/O addresses to see if anything else is
> trying to use 0x300?  Any other suggestions welcome.
>
/proc/ioports

I would fix your routing table first - that will probably fix
things.  This does not look like an interupt or IP problem.
> 
> This is a fresh install of RH7.0 as of about two hours ago, so there
> shouldn't be any legacy settings to worry about.  (I was kinda hoping that
> the problem would go away with RH6.2, so did a clean install instead of an
> upgrade.)
> 
> Cheers,
> 
> James Zuelow
> 



_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list

Reply via email to