I tried running netconfig, but I don't even think the OS detects the card.
I'm new to linux, so I've got no clue to how to get the device to be
detected. It doesn't show up during bootup. ...If I add an interface in
Gnome's "Network Configuration," it names it eth0. ...then it shows up
during bootup, but it fails.
Any suggestions?
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Mikkel L. Ellertson
Sent: Saturday, October 21, 2000 5:17 PM
To: [EMAIL PROTECTED]
Subject: Re: ethernet problems ...please help!
On Sat, 21 Oct 2000, Andy Myers wrote:
> I just installed Red Hat Linux 7. I didn't get any network setup options
> during installation, which makes me think that my ethernet card was not
> detected. How can I set up my ethernet card now after installation?
>
> I have a Linksys LNE100TX card, which is supposed to be supported.
>
> Any place on the web where I can get help with this?
>
> Thanks!
>
run netconfig
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list
