As one of the other posts mentioned I suggest you get another card. I had two of
those cards that I got with a network kit. . .never got the card to work. I did alot
of diging on that particular card and found that some of them are not supported at
all. While the variants of the tulip driver support most of them it turns out that
Linksys used different chips on some of the cards and changed the design a little here
and there. Depending on which version of the card you have you may never get it to
work. I can't say that the card you have will definately not work, but I know
personally that it is much easier to just use another card.
Good luck
-DRW
On Sat, 21 Oct 2000 17:07:51 -0400, you wrote:
> I just installed Red Hat Linux 7. I didn't get any network setup options
> during installation, which makes me think that my ethernet card was not
> detected. How can I set up my ethernet card now after installation?
>
> I have a Linksys LNE100TX card, which is supposed to be supported.
>
> Any place on the web where I can get help with this?
>
> Thanks!
>
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Darren R. Weber
[EMAIL PROTECTED]
AIM: TuxUser
ICQ#: 2849193
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list
