Ok, I tried on the enigma list with no luck, so I'm going to try here.
Basic question is: Does anyone have any idea what I might be doing wrong
that I would get multiple duplicate default routes when I boot up? I have
to remove all but one of them by doing "route del -net 0.0.0.0" to get
things back to normal.
The message below provides a bit more detail on my
/etc/network-scripts/ifcfg-* files...
-t.
> -----Original Message-----
> From: Furnish, Trever G
> Sent: Tuesday, March 19, 2002 4:25 PM
> To: '[EMAIL PROTECTED]'
> Subject: Why do I get duplicate default routes?
>
> I'm obviously doing something wrong, but I'm not sure what - any advice
> would be appreciated. I'm certain this'll be an easy question for
> someone...
>
> When I bring up the system in question, which has two ethernet cards and
> several interface aliases ("eth0:0", "eth0:1", "eth1:0", etc), it comes up
> with multiple default route entries for the same gateway (as shown by
> /sbin/route -n). This seems to produce erratic (but definitely broken)
> behavior.
>
> I have the following files that I think are relevant under /etc/sysconfig:
> (addresses and hostnames have been changed to protect the innocent)
>
> network:
> Defines NETWORKING=yes, HOSTNAME=foo, GATEWAY=1.2.3.4
>
> network-scripts/ifcfg-eth0:
> Defines DEVICE=eth0, BOOTPROTO,BROADCAST, IPADDR, NETMASK, NETWORK,
> ONBOOT, TYPE, USERCTL, PEERDNS, GATEWAY=...
>
> network-scripts/ifcfg-eth0:0
> Defines DEVICE=eth0:0, USERCTL, ONBOOT, BOOTPROTO, BROADCAST,
> NETWORK, NETMASK, IPADDR
>
> network-scripts/ifcfg-eth0:1
> Defines DEVICE=eth0:1, USERCTL, ONBOOT, BOOTPROTO, BROADCAST,
> NETWORK, NETMASK, IPADDR
>
> network-scripts/ifcfg-eth1
> Defines DEVICE=eth1, BOOTPROTO, BROADCAST, IPADDR, NETMASK, NETWORK,
> ONBOOT, TYPE, USERCTL, PEERDNS, GATEWAY
>
> network-scripts/ifcfg-lo
> Defines BROADCAST, ONBOOT, NAME=loopback
>
> I've chopped out most of the actual numbers for brevity but I'll
> summarize: eth0's gateway is the same as the one in
> /etc/sysconfig/network. Eth1's gateway is specific for its network. Each
> interface and alias is on a seperate subnet but the default gateway is
> actually fine for all of the source addresses - it'll route for all of the
> interfaces.
>
> Can anyone tell me why I get the duplicate default route lines? If I
> repeatedly do "route del -net 0.0.0.0" until there's only one left,
> everything works again, but I need to prevent the duplicates from coming
> back the next time the box starts. Am I defining something in the wrong
> spot?
>
> It should probably be noted that I'm avoiding using redhat network config
> tool because when I used it from stock 7.2 it screwed up network settings
> a lot on another system. Also note all released redhat errata patches for
> 7.2 have been installed - otherwise the system is pure enigma.
>
> --
> Trever
>
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list