On 14:09 10 Apr 2002, Ismael Touama <[EMAIL PROTECTED]> wrote:
| in order to set the mod_perl module to apache I run the following command
| line:
| perl Makefile.PL
| 
| But I guess I take a bad module.
| I want to restart the operation but with a clean & stable state,
| so I want to reset this command, is there a way ?

Being paranoid, I just remove the module source and unpack a fresh copy from
the tarball. Most likely you can just say:

        perl Makefile.PL

again, but how do you know? I don't, so I back out and do it all again.
It's not too hard.
-- 
Cameron Simpson, DoD#743        [EMAIL PROTECTED]    http://www.zip.com.au/~cs/

It's amazing how much 'mature wisdom' resembles being too tired.
        - Lazarus Long



_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list

Reply via email to