Ok here is something quite odd: tcpdump shows the arp reply from the server as: arp reply 192.168.0.5 is-at 0:e0:98:88:3a:2b while on the client it shows the correct MAC address: 0:e0:98:98:3a:3b
I have tried hardwiring both with the following command in /etc/pcmcia/config.opts: module "pcnet_cs" opts "hw_addr=0x00,0xe0,0x98,0x88,0x3a,0x2b" I feel like I am getting somewhere... thing is though.. this low level stuff is a bit out of my league. I can troubleshoot it, but I have no idea how to fix it. - Matt Bradford ----- Original Message ----- From: "Matthew Bradford" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Monday, June 03, 2002 11:12 AM Subject: Re: Question about PCMCIA networking > Unfortunately if I boot with everything removed from the system then it is > just like me not having the card in normally. When I put it in the card > services daemon will pick it up right away. If I don't have card services > running then nothing works. :-P Thanks for the idea though. > > - Matt Bradford > > > ----- Original Message ----- > From: "ABrady" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Monday, June 03, 2002 2:47 AM > Subject: Re: Question about PCMCIA networking > > > > On Mon, 3 Jun 2002 01:34:48 -0400 > > "Matthew Bradford" <[EMAIL PROTECTED]> wrote: > > > > > One more thing: > > > I know the slot isn't bad because it was _just working_ with that > > > card > > > and I tried a modem in there and it worked fine. Also I know the card > > > is still good because it works fine in another laptop running > > > Windows98. > > > > > > - Matt Bradford > > > > You don't say, I'm not sure with a laptop, and this is a wild guess > > based on things that work with desktops (sometimes). > > > > Have you rebooted without the card, removed all references to it > > (/etc/modules.conf and networking) and rebooted with it installed? Being > > an NE2K clone might require some manual configuration once again. I > > don't use ISA boards any more, but I remember they required some > > additional parameters to get them working (IRQ, I think it was, or IO, > > but not both). I had a couple of NE2K clones that were ISA and needed > > those things to work. > > > > That's my best (and only) shot. > > > > > ----- Original Message ----- > > > From: "Matthew Bradford" <[EMAIL PROTECTED]> > > > To: <[EMAIL PROTECTED]> > > > Sent: Monday, June 03, 2002 1:31 AM > > > Subject: Question about PCMCIA networking > > > > > > > > > > I am totally stumped. > > > > > > > > Here is the issue: I am running an NEC Versa 5080/64mb RAM/3gb HD > > > > and I just put a fresh install of RH7.3 on it. Now here is where > > > > issues come in... > > > > > > > > I have a SMC8040TX network card which is supposed to be NE2000 > > > > compliant. So it just automagically loads the pcnet_cs.o module. > > > > The first time I inserted the card it worked wonderfully. I got a > > > > DHCP address and I could get to the net and bring up any page I > > > > wanted to. Then I made the mistake of turning my laptop off. :-/ > > > > > > > > Now when I boot up (changing no settings) the card is detected and > > > > the driver is loaded (known from hearing both beeps and doing an > > > > lsmod) but it will not transmit anything over the network. It is as > > > > if it can only > > > listen > > > > to the traffic on the rest of the network but not participate. I > > > > can do > > > an > > > > 'ifconfig eth0 up' and it shows up in my card listing and then do a > > > > 'tcpdump -i eth0' and it shows every single packet flowing through > > > > the network. If I try and hardwire an address to the card > > > > ('ifconfig eth0 192.168.0.5 up') then it shows the IP address but I > > > > cannot ping anything. This is very frustrating since it worked > > > > perfectly the first time. > > > > > > > > To sum up: fresh install of RH7.3 NIC works perfectly. Reboot and > > > > it becomes a silent partner on the network. Will not join in the > > > > chatter anymore... even when I uninstall PCMCIA support and put it > > > > back in. > > > > > > > > Any ideas? > > > > - Matt Bradford > > > > > > > > > > > > > > > > _______________________________________________ > > > > Redhat-list mailing list > > > > [EMAIL PROTECTED] > > > > https://listman.redhat.com/mailman/listinfo/redhat-list > > > > > > > > > > > > > > > > _______________________________________________ > > > Redhat-list mailing list > > > [EMAIL PROTECTED] > > > https://listman.redhat.com/mailman/listinfo/redhat-list > > > > > > -- > > Well, what was the ham cured OF? > > > > > > > > _______________________________________________ > > Redhat-list mailing list > > [EMAIL PROTECTED] > > https://listman.redhat.com/mailman/listinfo/redhat-list > > > > > > _______________________________________________ > Redhat-list mailing list > [EMAIL PROTECTED] > https://listman.redhat.com/mailman/listinfo/redhat-list > _______________________________________________ Redhat-list mailing list [EMAIL PROTECTED] https://listman.redhat.com/mailman/listinfo/redhat-list