On Tue, 9 Jul 2002, Anthony Abby wrote:

> Could you not add eth0 first... then add eth1 after you finish configuring
> the first NIC?  That way there'd be no confusion which was which.

It doesn't work that way, especially when you have multiple, identical 
NICs.

In the boxes I've had with multiple, identical NICs, the assignment order 
is usually in the same order up or down the bus. Can't say I've tried more 
than 2 NICs, though, all the same type. The good news is that the 
assignment order doesn't change that I've seen.

The best method I've found is to use different chipset NICs, the put 
entries in /etc/modules.conf for each, ie 'alias eth0 8139too'. When the 
modules loads, the correct device will be associated with that NIC. 
Granted, with 5 NICs that will be a pain.

Later,

Bill Carlson
-- 
Systems Programmer    [EMAIL PROTECTED]         | Anything is possible,
Virtual Hospital      http://www.vh.org/      | given time and money.
University of Iowa Hospitals and Clinics      |       
Opinions are mine, not my employer's.         | 



_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list

Reply via email to