Mohd.Irfan R Khan wrote:
----------------->>>>
disable UDMA option from bios of ur motherboard or change the hard drive
cable if it is not UDMA cable. i.e. 80 Pin
> Hi:
>
> I just installed RH7.2 on a PIII with a 2.5 in Harddisk and the following
> error
> message shows up during boot. hda1(/boot) hda2(/) are mounted but not the
> reset partitions(/home, /usr, /tmp, /var). Can anyone help ? Thanks,
>
> block: queued sectors max/low 168037kB/56012kB, 512 slots per queue
> RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
> Uniform Multi-Platform E-IDE driver Revision: 6.31
> ide: Assuming 33MHz PCI bus speed for PIO modes; override with idebus=xx
> PIIX4: IDE controller on PCI bus 00 dev 39
> PIIX4: chipset revision 0
> PIIX4: not 100% native mode: will probe irqs later
> ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:DMA
> hda: TOSHIBA MK3017GAP, ATA DISK drive
> hdb: FX140S, ATAPI CD/DVD-ROM drive
> ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> hda: 58605120 sectors (30006 MB), CHS=3648/255/63, UDMA(33)
> ide-floppy driver 0.97
>
> >>Partition check:
> >>hda:hda: timeout waiting for DMA
> >>ide_dmaproc: chipset supported ide_dma_timeout func only: 14
> >>hda: status error: status=0x58 { DriveReady SeekComplete DataRequest }
> >>hda: drive not ready for command
> >>hda1 hda2 hda3
> >>hda: timeout waiting for DMA
> >>ide_dmaproc: chipset supported ide_dma_timeout func only: 14
> >>hda: status error: status=0x58 { DriveReady SeekComplete DataRequest }
> >hda: drive not ready for command
>
> Floppy drive(s): fd0 is 1.44M
> FDC 0 is a post-1991 82077
> ide-floppy driver 0.97
> md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
> md: Autodetecting RAID arrays.
> md: autorun ...
> md: ... autorun DONE.
----------------->>>>
Try ide=nodma at install prompt
--
redhat-list mailing list
unsubscribe mailto:[EMAIL PROTECTED]?subject=unsubscribe
https://listman.redhat.com/mailman/listinfo/redhat-list
