It tells you in the program book how to ID the pin. Its all software. Good luck! Russ
----- Original Message ----- From: "jfrohoff" <[EMAIL PROTECTED]> To: <Repeater-Builder@yahoogroups.com> Sent: Wednesday, April 14, 2004 2:50 PM Subject: [Repeater-Builder] TKR-850 - Where to get CTCSS enable signal? > In the course of connecting my new TKR-850 to my Arcom RC210 > controller I found out that the repeater's "Squelch Control" ouput is > not actually a CTCSS squelch signal, it is a COS signal only. In > other words, the "SC" pin goes from 5v to 0v whenever ANY signal is > on the receiver channel, whether or not it has the right CTCSS with > it. The CTCSS is enabled for the channel in the programming (173.8), > but it only cuts off the audio. The CTCSS enable is not reflected on > the repeater's SC pin. When I change to the wrong CTCSS code on my > handheld, the receiver speaker is quiet, and no audio gets to the > controller, but the "busy" light on the front lights and the SC pin > goes to 0v. > > I cannot see any other output pin for CTCSS enable ... so my option > appears to be either to use an external CTCSS decoder or to find a > signal in the receiver that does reflect the true CTCSS enable state. > > Anyone deal with this issue on a TKR-850? > > Thanks! Jim K7RNR > > > > > > > > Yahoo! Groups Links > > > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/