Try giving the deviation control a spritz of cleaner and then run it back and forth several times.
Chuck WB2EDV ----- Original Message ----- From: "Doug Bade" <[EMAIL PROTECTED]> To: <Repeater-Builder@yahoogroups.com> Sent: Saturday, September 18, 2004 2:25 PM Subject: Re: [Repeater-Builder] Repeater audio not passing > I am dealing with a similar problem with a Mastr II and a NHRC controller. > The audio sometimes fades out dropping to a very low level, and changes > while you are listening to it on a repeater user, although it comes back > all by itself. It seems to be an analog problem as opposed to just cutting > out all together... I am suspecting ( and working on correcting by parts > changes) that it is a bad cap in line or reverse bias on a cap or such. The > coupling caps are polarized and mic high has a bias on it, and if the > potential get reverse of the coupling caps I think it may be the issue.. I > thought I had it solved but it came back and then has been gone for a > couple weeks.. Next suspect is the audio hybrid on the exciter or maybe a > cap in the audio circuits... > Food for thought anyhow... > > At 12:06 PM 09/18/2004, you wrote: > >I have posted this before...thought I had it fixed ;-) > > > >GE Mastr Exec II with built in RC100 controller. Sometimes the > >repeater audio just comes and goes. This is ALL the audio, repeateed > >audio and all the tail beeps. However on it's own...it will come > >back. Thought it was that main plug set on the thing oxidizing...but > >after cutting the plug off and soldering directly to the pins...I > >don't think that is the problem any more. I have pushed and pulled > >on the connections to the RC100...so I don't think that is the > >problem. > > > >Again...the audio just comes and goes with no rhyme or reason :-( > >Ideas? > >Thanks, > >Robert > > > > > > > > > > > > > > > >Yahoo! Groups Links > > > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/