If the controller gives you the beep indication that it accepted the function change, then it is automatically saved. Are you programming/changing the DTMF access code (function code) for a particular function, or are you actually changing the parameter (such as the tail beep)? The reason I ask is that in order to change either of the parameters you mentioned, programming does not need to be enabled.
At any rate, if whatever you changed (and verified that it was indeed changed) reverts to default after a power cycle, then it's possible there may be a hardware problem in the controller. It is unlikely though, as they are pretty bullet proof. Richard, N7TGB -----Original Message----- From: va3vkk [mailto:[EMAIL PROTECTED] Sent: Sunday, March 13, 2005 10:28 AM To: Repeater-Builder@yahoogroups.com Subject: [Repeater-Builder] RC 1000 Controller When I program a function for example DTMF Muting enable/disable or Tail beep program Then disable controler codes all is OK but if I loss power it reverts back to previous setting This happens on new changes leading me to think I am missing a step to save them. All others seem OK VA3VKK Kim Yahoo! Groups Links Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
