Astron RS-35 vs the VS35m
There are slight differences between the two
boards... if it's already working for you...
you probably got away with it. If not you might
hold up until I look at my notes. Yes, one leg
of a resistor gets lifted to the control pot,
but check the actual values of the resistors on
the original vs the new board. I seem to remember
the variable board has different pc board values
in that location.
In short, the Variable Astron PS has a slightly
different regulator board circuit. Some cases
the same pc board (not all), but different part
values, some parts added and left off the board.
skipp
--- Mike
> Skipp,
> I think I got "wired"... just ignored the
> off-hand components, and forged > onward.
> I took a minute, but I figured out why it
> looked so different... the supply is a
> VS35M.. ya gotta lift one resistor, and run
> it through the voltage pot.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
