I just joined the S-Com list and I posted this question there - but as a new member it has to wait to be moderated so I appologize for asking on two lists but I figure there are some 7K experts here and I hope I can get an answer before I waste too much more time.
I have a very recent S-Com 7000 controller with Vyex DAB and ver 2.04 controller firmware installed. I have spent countless hours trying to program the 7K through the Vyex serial port using the process described in the Vyex documentation on page 23.[i.e. ! {PW} CMD ##] None of the commands appeared to work. What I finally discovered is that if I cold start the 7K by powering it on with the reset button held down - then it will accept commands and programming from the Vyex serial port - but only until the first time the power is cycled to the controller [warm start] or if a REBOOT command is issued from the DAB serial port. After that commands from the serial port do not execute - even though the same command will still execute if entered by DTMF. Is there any way around this problem or am I missing something simple? Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/